Your water heater is one that is used and much more costly appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating and costs.

Regular flushing of the water heater has become single most important step you consider to prolong its service life this particular save energy. Over a period of time, sediments mount up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regions of the country, the average water heater lasts 3-5 years. Regularly flushing your water heater can double living of your hot water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s economy. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.

To drain your water heater, initially you should set the thermostat to pilot (if it is really a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on a water inlet line going into your water heater. Equipped to connect a garden hose to the drain valve located at the bottom of the heater tank. Open the drain and allow it to function until all of the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the water flows out quickly. This will allow air to vent off of the heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas possess hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and merchandise to fit the bill.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Back Maintenance HVAC, Plumbing Tactics Reduce Emergencies

You May Also Like